Water

Water is a fluid block that can be a barrier to travel or a useful resource.

Water

Where Found

Water occurs naturally on the surface of a generated world in the form of ponds, lakes, and oceans. It can also spawn underground.

Flowing

It's possible for water to flow from one block to another, either when an adjacent block is removed, a block is added in space occupied by water, or when a bucket of water is emptied. Water will seek to fill the lowest available space but will not decrease in volume doing so, which can result in spaces being partially filled with water.

Water will flow over drop-offs and "splash" across the top of blocks. This can cause unexpected problems as water will dislodge placed items such as ladders or oil lanterns, dropping them for pick-up by the next Blockhead that passes them. Other placed items such as steel lanterns are unaffected.

Whether water will flow between two adjacent partially filled blocks appears to be determined by comparing their relative levels. If there is insufficient difference, there will be no flow. This can result in a very gentle, descending gradient across long expanses. (In one test, there was a drop of 28 pixels over a span of some 93 blocks with 80-pixel blocks after the water settled.) A significant difference in water height will cause "splash" particles to be produced as the water flows.

Flowing water will "push" items floating on top of it in the direction of the flow.

When multiple water blocks are directly over air blocks, there may be a flickering pattern of air and water as the two trade places.

Freezing

Free-standing water (or poured from a bucket) in an area experiencing sufficient cold (such as falling snow) or space may freeze into ice if it sufficiently fills a block. Trace water may disappear. Under warmer conditions, ice may melt into water.

Water close enough to cold air will freeze into ice, the distance dependent on the degree of cold. Conversely, ice close enough to warm air will melt.

Boiling

Free-standing water that's close enough to a heat source (such as magma, a campfire, a furnace, or burning blocks) will begin boiling, giving off "puffs of steam" in the form of white dots that quickly shrink and disappear.

Water at the correct temperature, will, as of version 1.3, heal a Blockhead standing in it.

Evaporation

If standing water is low enough in a block space, it may "evaporate" and despawn. When water is less than 1/28 of a block, it disappears from that block. This may allow water from an adjacent block to flow in and repeat the process, eventually lowering the water level in the other block to less than 1/28 too. This effect can slowly clear large areas of shallow water.

Also, if water fills less than one whole block of water on top of magma, it does not turn into basalt and instead evaporates into steam.

Harvesting

It's not possible to pick up water directly, but may be picked up and carried when frozen into ice and allowed to melt when placed later.

Using a bucket on water will change the bucket into a bucket of water. This can be done on even partially filled spaces containing more than one-eighth of a block of water.

Drowning

A Blockhead who has its head fully immersed in water will suffer from a lack of air and begin reducing their air bar. But if you run out of air in warm water you will not drown neither will any health be drained without being healed.

Uses

Water cannot be used directly for crafting, but is needed for some crafting recipes in the form of a bucket of water.

Kelp cannot be planted in a block that isn't under sufficient water.

Placing water directly atop magma will create a block of unharvested basalt.

Notes

Due to some quirks of how it's implemented, it's possible to generate water in two ways:

Water that partially fills a space will freeze into a full block of ice, which may then melt into a full block of water. However, as of 1.4, ice melts back into the same one-block water level that froze.
Water spilling into two or more open blocks may allow each partially filled space to be picked up by a bucket, which when emptied will produce a full block of water.

If a solid block is placed in a well-submerged location, there is little noticeable change in water level. This suggests that the water is replaced rather than displaced. This does not happen near or at the surface of the water unless there is a solid block immediately above where the new one is being placed.

Gallery

Water boils near magma
Water draining down an irregular vertical shaft, note the flowing accumulation at the bottom
Over 100 blocks of water draining from an ocean into an unseen submarine cave; it started when the player's Blockhead approached
Snow hanging in the air, the ice it had been on melted into partial water