Electric Elevator Motor

From The Blockheads Wiki
Revision as of 11:35, 9 August 2014 by >Abcboy (→‎Where Found)
This article is a stub. 
You can help The Blockheads Wiki expanding it.
Electric Elevator Motor
Electric Elevator Motor
Electric Elevator Motor


Category Crafting Surface
Use Travel
Tool
Stackable Yes (99)


"Place above or below shaft."

An electric elevator motor is a crafting surface that uses electricity to bring connected elevator shafts to full function.

Appearance

Resembling a crafting surface, an electric elevator motor is silvery white in color with shading suggesting a circle on its surfaces.

Where Found

An electric elevator motor is created at a metalwork bench (either electric or level 2) for 1 steel block, 1 electric motor, and 10 copper wires.

Location Input Item 1 Input Item 2 Input Item 3 Input Item 4 Input Item 5 Crafted Output
+ + + + =
Lvl. 2 Metalwork Bench or Electric Metalwork Bench Steel Block Electric Motor Copper Wire [[]] [[]] Electric Elevator Motor
Quantity 1 1 10 {{{Qty4}}} {{{Qty5}}} 1
Rush Cost
8
Double-Time
4

Use

There is no crafting possible with an electric elevator motor. Instead, by being positioned immediately above or below (only one per column of shafts is needed) a continuous series of elevator shafts and connected to a source of electricity, it allows blockheads to make full use of the shafts.

Tapping on the elevator motor will cause a blockhead to remove it.

When initially connected to a source of electricity, an electric elevator motor may begin to draw power for a few seconds. It will then remain idle until connected elevator shafts are used.

Fuel

Electric Elevator Motors do not consume items as fuel.